PIC16C711-04/P【PDF 51/177 页】IC MCU OTP 1KX14 A/D 18DIP

144

7593L–AVR–09/12

AT90USB64/128

Bit 5 – ICFn: Timer/Countern, Input Capture Flag

This flag is set when a capture event occurs on the ICPn pin. When the Input Capture Register

(ICRn) is set by the WGMn3:0 to be used as the TOP value, the ICFn Flag is set when the coun-

ter reaches the TOP value.

ICFn is automatically cleared when the Input Capture Interrupt Vector is executed. Alternatively,

ICFn can be cleared by writing a logic one to its bit location.

Bit 3– OCFnC: Timer/Countern, Output Compare C Match Flag

This flag is set in the timer clock cycle after the counter (TCNTn) value matches the Output

Compare Register C (OCRnC).

Note that a Forced Output Compare (FOCnC) strobe will not set the OCFnC Flag.

OCFnC is automatically cleared when the Output Compare Match C Interrupt Vector is exe-

cuted. Alternatively, OCFnC can be cleared by writing a logic one to its bit location.

Bit 2 – OCFnB: Timer/Counter1, Output Compare B Match Flag

This flag is set in the timer clock cycle after the counter (TCNTn) value matches the Output

Compare Register B (OCRnB).

Note that a Forced Output Compare (FOCnB) strobe will not set the OCFnB Flag.

OCFnB is automatically cleared when the Output Compare Match B Interrupt Vector is exe-

cuted. Alternatively, OCFnB can be cleared by writing a logic one to its bit location.

Bit 1 – OCF1A: Timer/Counter1, Output Compare A Match Flag

This flag is set in the timer clock cycle after the counter (TCNTn value matches the Output Com-

pare Register A (OCRnA).

Note that a Forced Output Compare (FOCnA) strobe will not set the OCFnA Flag.

OCFnA is automatically cleared when the Output Compare Match A Interrupt Vector is exe-

cuted. Alternatively, OCFnA can be cleared by writing a logic one to its bit location.

Bit 0 – TOVn: Timer/Countern, Overflow Flag

The setting of this flag is dependent of the WGMn3:0 bits setting. In Normal and CTC modes,

the TOVn Flag is set when the timer overflows. Refer to Table 15-4 on page 138 for the TOVn

Flag behavior when using another WGMn3:0 bit setting.

TOVn is automatically cleared when the Timer/Countern Overflow Interrupt Vector is executed.

Alternatively, TOVn can be cleared by writing a logic one to its bit location.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购